Learning to weld

Well, I could avoid it no more; the time had come for me to learn how to MIG weld. I have been busy reading, watching instructional videos and seeking guidance from my good friend T-bone about this easy-to-learn-difficult-to-master skill. However, I knew that to really progress with this project I just needed to get many hours of practice under my belt. No time like the present!

Allow me to introduce the vintage beast that I have been learning on:

Using some scrap metal from the old floor pans, I set about honing my skills. This was one of my first few efforts:

In the sequence above you will see the original scrap piece as it was before (top left). I cut it in half with the angle grinder and held the pieces together using an �Intergip�, which is a fantastic little welding clamp manufactured by Frosts (top right). I then proceeded to make my not-so-attractive weld (bottom left). I then carefully ground the weld flat with the flap disc so that the joint became invisible (bottom right). I decided to give the area a quick lick of primer to simulate how the repair would look when painted:

I was impressed with the result � the joint was barely detectable! Not a bad start if I do say so myself. However, I still need plenty more practice to get �a feel� for the welder and learn how to manipulate the settings to get the best possible penetration of weld. I am optimistic that by the new year I will be ready to begin welding the car and that�s when the really fun will begin!